免费在线a视频_九九热精品视频在线播放_深夜网站在线_amazon亚马逊官网_亚马逊中文官网_国产无吗视频

NewsHome > News > Industry dynamics

How to check the working condition of ironing plate for paver
release time:2019-3-28 15:52:28      hit count:2908


(1) Place the paver on the flat ground, set the elevation value to zero, drop the ironing pull and place it on a flat loose sandstone layer. After several minutes, put forward the ironing plate. Observe the indentation of the front end of the ironing plate on the sandstone layer. If the indentation is obvious, it indicates that the ironing pull is in normal condition; if the indentation is not obvious or the indentation appears in the back, it indicates that the ironing plate has appeared to varying degrees. Wear. After many experiments, it was found that the indentation was not obvious, which indicated that the ironing plate had been worn. The elevation of the paving machine is higher than that of the new machine, which also explains this problem.

(2) In order to further explore the extent of wear and tear of the ironing plate (of course, the deformation of the arm of the ironing plate can also be checked out in extremely unexpected circumstances), the pads with thickness of 1mm, 2mm, 2.5mm and 3mm are added at the lower connection of the ironing plate and the lifting arm respectively to increase the original elevation angle of the ironing plate and observe the improvement of the failure respectively. It is found by experiments that the pads with thickness of 1mm, 2mm, 2.5mm and 3mm are added to the lower connection of the ironing plate and the After adding the gasket with the thickness of 2.5mm, no failure was found in the paving of medium-sized asphalt concrete, but the paving of fine-grained asphalt concrete still has the phenomenon that the thickness is difficult to control.

(3) Through the inspection of (1) and (2), it can be concluded that the failure phenomenon has nothing to do with the automatic leveling system, but has something to do with the wear of the ironing plate. Considering that the failure phenomenon is related to the condition of the asphalt mixture and the running speed, it should be suspected that the wear of the front rammer caused by the wear of the ironing plate bottom plate can lead to these failure phenomena. The frequency of rammer is lowered, but the effect is not obvious. The disassembly inspection found that the front rammer had been severely worn, and the relative position between the lowest ramming stroke and the bottom plate of the ironing plate changed greatly.

When the rammer is in the lowest position, it is higher than the bottom plate worn by the ironing plate, which results in the front of the ironing plate forming a denser "material block" through the vibration and tamping of the rammer during paver paving. The "material block" has a greater buoyancy on the ironing plate than under normal conditions, thus preventing the pressing "feed" of the ironing plate, and at the same time, the serious wear and tear of the ironing plate bottom plate is also increased. The difficulty of downward pressure is aggravated, which leads to the phenomenon that the thickness of the leveling cylinder has not decreased although it has reached the maximum stroke position. With the increase of paving speed, the compactness of the compacted "material block" will be reduced, and the compactness will also be reduced, thus returning to the normal working state. In addition, under the same compaction effect, the "material block" formed by fine-grained asphalt concrete is denser than that of medium-grained asphalt concrete, so the failure phenomenon is much more serious when paving fine-grained asphalt concrete. As for the failure of the right side of the ironing plate, it is because the wear of the front part of the right side of the ironing plate and the rammer is much worse than that of the left side (in this case, the ironing plate has worn into trapezoidal cross section, the front part of the left side is only about 3 mm, while the normal thickness is 16 mm, and the front part of the left side wears more normally, about 13 mm).


Previous: What is the effect of adding retarder in cement concrete in sliding-form construction?
Next: How many meters can the curb stone slide be made a day? How is the construction efficiency?

Back to list

News you are interested in
主站蜘蛛池模板: xxx2高清在线观看免费视频 | 免免费看一级录像片 | 97国产情侣爱久久免费观看 | www.久久网| 91成人看片 | 亚洲大码熟女在线观看 | 免费av网站在线观看 | 国产麻豆放荡AV剧情演绎 | 99久久国产免费大片 | 内射巨臀欧美在线视频 | 亚洲理论av | 大地资源二中文在线观看官网 | 中文人妻无码一区二区三区 | 护士故意露出奶头让我吃奶 | 四虎影视库www111we | 免费不卡欧美自拍视频 | 99久久无码一区人妻A片红豆 | japan高清日本乱xxxxx | av在线色| 97在线视频人妻无码 | 隔壁人妻被水电工征服 | 人妻丰满熟妇AV无码区乱 | 久久精点视频 | 亚洲第一天堂无码专区 | 2017最新高清无码网站 | 日产特黄级日产片 | 日本深夜福利 | 一级片视频免费观看 | 99久久精品免费看国产 | 1717she国产精品高清在线观看 | 成人活性生交大片免费看 | 深夜福利免费 | 国产香蕉伊蕉伊中文在线视频 | 国产SUV精品一区二区33 | 日韩亚州 | 国产在线精品一区二区在线看 | 免费看日产一区二区三区 | 美女黄色网址 | 草莓AV福利网站导航 | 亚洲国产精品久久久久 | 好深好湿好硬顶到了好爽 |